The tools in this section are called Editing & Maneuvering tools. these tools are used to reshape existing shapes displayed at the count indicated by the Red Anchor of the Count Track. However, the power of these tools go much further than just editing a single count. These tools also create the transition to the count at the Red Anchor from the count at the Yellow Anchor. Typically the count at the Yellow Anchor is the count of the previous set you have completed.

For example, imagine you are working on Set #2 of your drill. Set #1 of your drill is at count 0 and Set #2 of your drill is at count 32. The Yellow Anchor is at count 0 and the Red Anchor is at count 32. Editing & Maneuvering tools will make changes to shapes at count 32 as well as create the transition between counts 0 to 32.

Editing & Maneuvering tools are always used on existing performers. Therefore, in order to make the Editing & Maneuvering accessible, you must select at least one performer on the field. Performers are selected with Selection tools such as the Pointer tool.

Click on the arrow next to Editing & Maneuvering Tools in the Table of Contents to the left to expand this section and begin.


Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.

Post your comment on this topic.

Please do not use this for support questions.
Contact Us

Post Comment