sample drill setup

This forum is to discuss Tips and Tricks you have learned while using the 3D Java program

Moderator:PywareTechSupport

Post Reply
bpbailey
Posts:1
Joined:Sat Aug 22, 2015 12:25 pm
sample drill setup

Post by bpbailey » Sat Aug 22, 2015 12:32 pm

so I'm looking at the sample drill #1 trying to figure out how to recreate this (especially to setup the symbols properly). If I'm looking at this drill properly did the drill writer start on set 2 and work backwards to when starting the drill. I'd like to start my drill with an integrated set like this and then pull them apart but can't seem to figure out how to individually place each member on the grid? :?:

thanks in advance,

bpb
los angeles ca

Pyware
Site Admin
Posts:1155
Joined:Fri Aug 19, 2005 10:38 am
Location:Argyle, TX
Contact:

Re: sample drill setup

Post by Pyware » Tue Sep 08, 2015 4:50 pm

Bob

I would suggest that you go through the tutorial. This will help you accomplish what you are looking for.
http://www.pyware.com/guide/3d/8.0/en/topic/3d-tutorial
Thank you
Dustin Merrell
Pyware Technical Support
940-240-8536

Post Reply