Previous Set

General questions about the use of the Pyware 3D software.

Moderator:PywareTechSupport

Post Reply
sallen1990
Posts:2
Joined:Fri Aug 07, 2015 10:36 pm
Previous Set

Post by sallen1990 » Fri Aug 07, 2015 10:40 pm

Today I had to re-format my hard drive and re-install pyware. I've got most of my setting back the way I like but there is one that is driving me crazy. The previous set is showing up as black dots and its very distracting from my current set. I had that turned off or at least light grey before and I can't figure out how to change this. Does anyone know where this setting is?

sallen1990
Posts:2
Joined:Fri Aug 07, 2015 10:36 pm

Re: Previous Set

Post by sallen1990 » Fri Aug 07, 2015 10:42 pm

ok I found it! just had to dig into the application settings

Post Reply