Copy/Paste into a final set

General questions about the use of the Pyware 3D software.

Moderator:PywareTechSupport

Post Reply
Gary McCarty
Posts:52
Joined:Sat Jun 14, 2014 1:35 pm
Copy/Paste into a final set

Post by Gary McCarty » Thu Aug 13, 2015 11:23 am

I have completed the design for a show's Opener. Now the BD wants to ADD a "Pre-show" section that will end with the first form in the original Opener. Is there a way to copy Paste that first form into the FINAL set for the Pre-show, without treating it a as all "new performers." That would take a LOT of time to re-do all the symbols, labels, etc.

Thanks for any suggestions!
-Gary-

Pyware
Site Admin
Posts:1155
Joined:Fri Aug 19, 2005 10:38 am
Location:Argyle, TX
Contact:

Re: Copy/Paste into a final set

Post by Pyware » Thu Aug 13, 2015 10:10 pm

Gary

Open the opener then go to file and choose new drill as a continuation file. Then choose to continue from count then enter count 0. This will then create a drill and then you can add page tabs and write backwards.
Thank you
Dustin Merrell
Pyware Technical Support
940-240-8536

Gary McCarty
Posts:52
Joined:Sat Jun 14, 2014 1:35 pm

Re: Copy/Paste into a final set

Post by Gary McCarty » Fri Aug 14, 2015 9:15 am

Thank you, Dustin!
I should have caught that one myself. ;-)

-Gary-

Post Reply