Drill rewrite in a production?

General questions about the use of the Pyware 3D software.

Moderator:PywareTechSupport

Post Reply
aaron.cole
Posts:2
Joined:Thu Sep 01, 2016 5:59 am
Drill rewrite in a production?

Post by aaron.cole » Thu Sep 01, 2016 6:02 am

Hi there,

Let's say I'm deleting a couple performers from a production with 2 or more drill files in it.

When I finish the first drill and move on to the second, is there a way to get the 2nd drill file to "reset to hold" from the end of the previous drill file and just continue working from there?

Do I have to use the drill rewrite tool? Is there another tool? Is there any tool to do this?

Pyware
Site Admin
Posts:1155
Joined:Fri Aug 19, 2005 10:38 am
Location:Argyle, TX
Contact:

Re: Drill rewrite in a production?

Post by Pyware » Thu Sep 01, 2016 11:35 am

You would need to either delete the performer from drill 2 or use the drill rewrite tool to delete the performers leaving a hole. Then you can open the first tune and copy the last set and paste it into the second tune matching the performers to the new revised locations.

Then you can continue rewriting from there.
Thank you
Dustin Merrell
Pyware Technical Support
940-240-8536

aaron.cole
Posts:2
Joined:Thu Sep 01, 2016 5:59 am

Re: Drill rewrite in a production?

Post by aaron.cole » Thu Sep 01, 2016 4:20 pm

Thanks. I just didn't think of literally copying and pasting the previous set after deleting the performers.

Post Reply