performers jump to other coordinates when starting new set

General questions about the use of the Pyware 3D software.

Moderator:PywareTechSupport

Pyware
Site Admin
Posts:1155
Joined:Fri Aug 19, 2005 10:38 am
Location:Argyle, TX
Contact:
Re: performers jump to other coordinates when starting new set

Post by Pyware » Fri Sep 02, 2016 12:48 pm

If you are going back and revising performer locations the new locations will not transfer to overwrite the next pages by default. If you want to enable the transfer of changed pages you will need to select the range (Last page you wrote to the end of the file) then select the performers and delete the transition. This will then accept the changed transitions again as if you were working on a new file.
Thank you
Dustin Merrell
Pyware Technical Support
940-240-8536

Post Reply