I have lines in and beyond the left side end zone. I understand how to shift the grid and can see these lines until I try to print the page.
How do I keep the grid shifted so I can see the lines when I try to print.
ENDZONES ... How do you get them to print?
Moderator:PywareTechSupport
Re: ENDZONES ... How do you get them to print?
To print the endzones you will need to load the field for printing endzones from the grid designer.
The grid designer is located in the Utilities Menu.
-Dustin
Pyware Customer Support
The grid designer is located in the Utilities Menu.
-Dustin
Pyware Customer Support
Re: ENDZONES ... How do you get them to print?
How do I load the end zones? I went into the grid designer and tried moving some of the lines to no avail.
Re: ENDZONES ... How do you get them to print?
Open the Grid designer and zoom the field out 2 times using the magnifying class in the upper right hand corner. Then locate the small yellow ovals in the lower left hand corner of the field. Drag one of the small yellow ovals 5yds to the left and right of the endzones. This will successfully change the print preferences for the drill chart.
-Dustin
Pyware Customer Support
-Dustin
Pyware Customer Support