Hello All,
I am working on a drill for a client and I am running into an issue that I've no encountered. There are lots of specific facings in the show however the 3d is ignoring any attempts to fix the facings in Playback. It either ignores the new instruction or just keeps the one from set one. I've tried telling it to both start and stop on certain counts however it continues to not register
Facings not staying
Moderator:PywareTechSupport
Re: Facings not staying
Can you set the facing at the count zero again then attempt to set the facing again?
If you still experience issues can you email us the file?
If you still experience issues can you email us the file?
Thank you
Dustin Merrell
Pyware Technical Support
940-240-8536
Dustin Merrell
Pyware Technical Support
940-240-8536