Coordinates not printing correctly

bevans · Post by **bevans** » Mon Aug 06, 2007 10:10 pm

I started teaching drill tonite and the drill was written on the yardline and halfway in between . Coord says for off the yardline 3.5 when it should be 4.0. On every amount it is off by one level. If I have the preferences on quarter steps and it supposed to be 4.0 it says 3.75 on the coord sheet.

Any ideas- what am I doing wrong? Do I have a preference set up wroing or a grid misplaced. most of the time I am the problem.

bevans · Post by **bevans** » Tue Aug 07, 2007 12:11 am

Sorry

Version 4.2.2

Mac OS 10.4.10

Post by **Pyware** » Tue Aug 07, 2007 11:31 am

It is very possible that this form is off of the yardline slightly. Please select the form and choose snap to Whole step and see if that changes the coordinate sheets.

bevans · Post by **bevans** » Tue Aug 07, 2007 3:58 pm

thanks That worked for most of the charts that are in a block, but there still is a problem on linear forms that intersect the lines.

bevans · Post by **bevans** » Thu Aug 09, 2007 11:46 am

Any Ideas- on the linear there is still a problem. When I zoom in and have it set on show 1 step grid the person is shown to be less than .10 off of the line (in fact the letter is covering the line), yet it says on the coord to be .5 off the yardline

bevans · Post by **bevans** » Thu Aug 16, 2007 4:24 pm

Anyone

bevans · Post by **bevans** » Thu Aug 23, 2007 8:18 pm

Thanks Dustin. I appreciate your response on email.