Changing Floor Covers in an existing Drill File

composer318 · Post by **composer318** » Sun Dec 11, 2011 3:52 pm

Is it possible to edit my floor cover in a file I am already working in, or do I have to start over with a new file with the new floor cover?

Post by **Pyware** » Sun Dec 11, 2011 10:19 pm

You would need to open the floor image in a paint program then make the changes you would like. At that point you can apply the Floor Cover image in the Grid Designer or through the Floor Cover Tool.

composer318 · Post by **composer318** » Mon Dec 12, 2011 10:19 pm

Actually - My problem is this - I scaled the grid incorrectly when I created my floor - The steps are too small for the size of the floor and as a result there are too many steps on the grid creating confusion for the performers. I just need to adjust the grid overlay - Any thoughts?

Post by **Pyware** » Tue Dec 13, 2011 8:28 am

If you go to the grid designer then you will be able to adjust the grid and the floor cover image will resize to the new size of the grid area.

composer318 · Post by **composer318** » Tue Dec 13, 2011 2:19 pm

That solves the problem for future use but it didnt adjust it in the existing file I am already working in. I am 15 sets in and I would like to not have to rewrite all of that drill if possible....

Thanks
Tim Nutting

Post by **Pyware** » Tue Dec 13, 2011 9:37 pm

The grid should apply to your current drill as well.

Pyware User Forums

Changing Floor Covers in an existing Drill File

Re: Changing Floor Covers in an existing Drill File

Re: Changing Floor Covers in an existing Drill File

Re: Changing Floor Covers in an existing Drill File

Re: Changing Floor Covers in an existing Drill File

Re: Changing Floor Covers in an existing Drill File