Pyware User Forums

Hi there,

This may have been addressed before, but I am a bit new and could not find the answer.

I decided in the drill I was writing today that I wanted to start the opening set and next 2 sets 8 steps more forward than I did originally. However, in the playback the counts in between the set points revert back to the original places I had put the dots. It just adjusts directly at the set points and then goes back to the original on the in between counts. Is there a way to fix this? Thanks a bunch....

Snaregirl wrote:Hi there,

This may have been addressed before, but I am a bit new and could not find the answer.

I decided in the drill I was writing today that I wanted to start the opening set and next 2 sets 8 steps more forward than I did originally. However, in the playback the counts in between the set points revert back to the original places I had put the dots. It just adjusts directly at the set points and then goes back to the original on the in between counts. Is there a way to fix this? Thanks a bunch....

Spread your anchors for the transition, highlight the performers, and select the Morph Tool. When the tool opens, don't move anyone, just press accept. This tells the performers to take a straight line path from point A to point B (or from your yellow anchor to red anchor).

Note: If the performers were transitioning via a follow the leader, this would not correct the issue. You would actually need to redo the follow the leader maneuver.

Once complete, watch the new transition. It should now look correct.

OOOH, I hate it when my drills do this. This always happens to me because of human error due to odder maneuvers that were solved with the Traditional Tools.

Perfect! Thanks a bunch...