Symbol Map Defaults
Moderator:PywareTechSupport
-
- Posts:5
- Joined:Sun Sep 21, 2014 4:01 pm
- Location:Pasadena, CA
- Contact:
Is there a way to save my changes to the symbol map so it always defaults to those symbols in any new drill I write?
Dr. Walter Simonsen
-
SimonsenMarchingDesigns.com
WalterSimonsen.com
Pasadena, CA
waltisbadical@gmail.com
-
SimonsenMarchingDesigns.com
WalterSimonsen.com
Pasadena, CA
waltisbadical@gmail.com
Re: Symbol Map Defaults
Go to Utilities and choose Cast list Editor.
Choose Edit Symbol Map.
Adjust the map the way you wish.
Press Save As Defaults.
These will then apply when you create new drills from that point on.
Choose Edit Symbol Map.
Adjust the map the way you wish.
Press Save As Defaults.
These will then apply when you create new drills from that point on.
Thank you
Dustin Merrell
Pyware Technical Support
940-240-8536
Dustin Merrell
Pyware Technical Support
940-240-8536
-
- Posts:5
- Joined:Sun Sep 21, 2014 4:01 pm
- Location:Pasadena, CA
- Contact:
Re: Symbol Map Defaults
Thanks Dustin!
Dr. Walter Simonsen
-
SimonsenMarchingDesigns.com
WalterSimonsen.com
Pasadena, CA
waltisbadical@gmail.com
-
SimonsenMarchingDesigns.com
WalterSimonsen.com
Pasadena, CA
waltisbadical@gmail.com