Pyware User Forums

Wasn't sure where to put this one but here goes:

Is there a way to adjust the actual placement of the symbol? If you notice on the drill charts a symbol is never centered where you write them. Is there a way to do this? Is it in the font size and type of font? Which the cast sheet has the symbol and a crosshair where the dot actually is according to the symbol? I send the cast sheet out with the drill and it's ignored; then I end up getting calls on how to read the drill with the symbols.

What font are you using and what platform are you running on this could help de diagnose the issue.

Dustin,

I am using Java Deluxe Font Size 40 (the font from Craig Harms-Creative Consultation). I am using a PC Pentium 4 XP Home Edition. Java 4 Beta. But this issue was the same on the 3.0.7 Java as well as the 2.0 versions. Thanks!

Pyware Tech Support wrote:What font are you using and what platform are you running on this could help de diagnose the issue.

That is an error within the font. I will check with the creator of that font to see it a change can be made to correct the way the font lines up to the position.