Symbol Question

visguy · Post by **visguy** » Sun Jun 04, 2006 2:33 pm

Wasn't sure where to put this one but here goes:

Is there a way to adjust the actual placement of the symbol? If you notice on the drill charts a symbol is never centered where you write them. Is there a way to do this? Is it in the font size and type of font? Which the cast sheet has the symbol and a crosshair where the dot actually is according to the symbol? I send the cast sheet out with the drill and it's ignored; then I end up getting calls on how to read the drill with the symbols.

Thanks
G. Ron Ryles
Freelance Designer
Charlotte, NC

PywareTechSupport · Post by **PywareTechSupport** » Thu Jun 08, 2006 9:11 am

Double Post

See the following thread http://pyware.com/phpBB2/viewtopic.php?t=95