Wasn't sure where to put this one but here goes:
Is there a way to adjust the actual placement of the symbol? If you notice on the drill charts a symbol is never centered where you write them. Is there a way to do this? Is it in the font size and type of font? Which the cast sheet has the symbol and a crosshair where the dot actually is according to the symbol? I send the cast sheet out with the drill and it's ignored; then I end up getting calls on how to read the drill with the symbols.
Thanks
G. Ron Ryles
Freelance Designer
Charlotte, NC
Symbol Question
Moderator:PywareTechSupport
-
- Site Admin
- Posts:139
- Joined:Fri Aug 19, 2005 1:00 pm
- Location:Texas
- Contact: