I have just started to work on a new drill. After I "accept" each action in the drill, the circle control tool pops up. Somewhere along way I must have inadvertently created this "shortcut." How does one eliminate/delete a tool shortcut? Any assistance greatly appreciated.
Thanks in advance
Delete/Remove Tool Shortcut?
Moderator:PywareTechSupport
Re: Delete/Remove Tool Shortcut?
You have the Circle Tool set to the default tool.
To change this Right click on the Pointer selection tool to set it to default again.
To change this Right click on the Pointer selection tool to set it to default again.
Thank you
Dustin Merrell
Pyware Technical Support
940-240-8536
Dustin Merrell
Pyware Technical Support
940-240-8536
Re: Delete/Remove Tool Shortcut?
Thanks Dustin. I'm a novice user but figured it had to be something along those lines...I just couldn't find the solution in the manual or in the forums.
Re: Delete/Remove Tool Shortcut?
This is a list of all of the special shortcuts that the software has.
http://www.pyware.com/3dguide/modifierlist.html
http://www.pyware.com/3dguide/modifierlist.html
Thank you
Dustin Merrell
Pyware Technical Support
940-240-8536
Dustin Merrell
Pyware Technical Support
940-240-8536